Our websites use cookies on your device to give you the best user experience. By using our websites, you agree to the placement of these cookies. To learn more, read our privacy policy.

GATEWAY KNX DALI-2 2CH

General information

DALI Product ID11481
Product NameGATEWAY KNX DALI-2 2CH
Brand NameBlumotix srl
StatusCertified: DALI-2
Product Part NumberBX-DALIPRO2
GTIN8053369044811
Bus unit configuration-

Testing

Test conditionsTambient = 23°C This is a rebrand of device ID 6812
Test typeFull
Family reference product ID-
DALI test sequence software version2.6.0.0

Technical

Bus current consumption

Maximum current consumed from the bus power supply. If no value shown, 2mA is required.

Guaranteed supply current

Current that this bus power supply can provide. Total must be sufficient to provide the total "bus current consumption" of all devices.

148
Maximum supply current

Highest current that this bus power supply may provide. Total must not exceed 250mA.

250

Hardware/firmware information

If multiple versions exist then contact the manufacturer for details of the older versions.

Hardware version1.0
Firmware version3.0

Product reference product description

Gateway Dali/KNX

Description

Blumotix DALI-Gateway secure is a multimasterapplication controller for controlling electronic ballasts with two DALI-Interfaces via the KNX installation bus (with / without KNX Data Secure communication). It supports ballasts according to EN 62386-102 ed1 (DALI-1), devices according to EN 62386-102 ed2 (DALI-2). Special DALI ballasts for colour control (RGB(W)/TW) according to EN 62386-209 will also be supported. Sensors (input devices) and additional ‘other application controllers’ are supported.

DALI parts and versions

1012.0
1032.0

Product properties

The application controller supports control gear with no device types, those with 1 device type and those with more than 1 device type. For certifications before October 2025, check with the manufacturer.

This product can be used to update the firmware of other products that implement part 105 Firmware Transfer.

Sensors, switches, push-buttons, etc.

Maximum current consumed from the bus power supply. If no value shown, 2mA is required.

“Other properties” do not imply certification to such standards.



Reference design of firmware or hardware available