Our websites use cookies on your device to give you the best user experience. By using our websites, you agree to the placement of these cookies. To learn more, read our privacy policy.

DALI-2 modular relay module

General information

DALI Product ID5946
Product NameDALI-2 modular relay module
Brand NameNiko
StatusCertified: DALI-2
Product Part Number310-02320
GTIN5413736388161
Bus unit configuration-

Testing

Test conditions
Test typeFull
Family reference product ID-
DALI test sequence software version2.3.2.0

Technical

Bus current consumption

Maximum current consumed from the bus power supply. If no value shown, 2mA is required.

2.9
Guaranteed supply current

Current that this bus power supply can provide. Total must be sufficient to provide the total "bus current consumption" of all devices.

0
Maximum supply current

Highest current that this bus power supply may provide. Total must not exceed 250mA.

0

Hardware/firmware information

If multiple versions exist then contact the manufacturer for details of the older versions.

Hardware version9.0
Firmware version5.0

Product reference product description

DALI_2 relay

Description

This modular relay module enables you to control non-dimmable 230 V loads via a DALI bus. It allows lighting ballasts with no DALI interface to be switched ON and OFF by DALI commands. The maximum switching current of the relay module is 8 A. The lifetime of the integrated relay contact is extended by zero-cross switching technology. The relay module fulfils DALI requirements IEC 62386 parts 102 (control gear) and 208 (DALI device type 7). The DALI addressing and configuration can be done via the Niko detector tool app. The DALI relay module is directly connected to and powered by the DALI bus. Note that a separate DALI bus power supply is required. The DALI-2 relay module is DIN-rail mounted in an electrical distribution board.

DALI parts and versions

1012.0
1022.0
2082.0

Product properties

LED drivers, ballasts, ECGs, etc.

Maximum current consumed from the bus power supply. If no value shown, 2mA is required.

“Other properties” do not imply certification to such standards.



Reference design of firmware or hardware available