Our websites use cookies on your device to give you the best user experience. By using our websites, you agree to the placement of these cookies. To learn more, read our privacy policy.

DALI Broadcast 4fach

General information

DALI Product ID9844
Product NameDALI Broadcast 4fach
Brand NameFeller
StatusCertified: DALI-2
Product Part Number36164-04-A.REG
GTIN7613175075990
Bus unit configuration-

Testing

Test conditionsT_ambient = 23°C V = 230VAC / 50 Hz
Test typeFull
Family reference product ID-
DALI test sequence software version2.5.0.0

Technical

Bus current consumption

Maximum current consumed from the bus power supply. If no value shown, 2mA is required.

Guaranteed supply current

Current that this bus power supply can provide. Total must be sufficient to provide the total "bus current consumption" of all devices.

64
Maximum supply current

Highest current that this bus power supply may provide. Total must not exceed 250mA.

250

Hardware/firmware information

If multiple versions exist then contact the manufacturer for details of the older versions.

Hardware version1.0
Firmware version1.0

Product reference product description

-

Description

The Feller DALI-Actuator 4fach (english DALI Broadcast 4fold) is a multi-master application controller with four DALI Broadcast-Outputs for controlling electronic ballasts via the KNX installation bus (with / without KNX Data Secure communication). It supports ballasts according to EN 62386-102 ed1 (DALI-1), devices according to EN 62386-102 ed2 (DALI-2). Special DALI ballasts for colour control (RGB(W)/TW) according to EN 62386-209 will also be supported. In addition DALI-2 sensors (as Application Controller) in broadcast mode will supported.

DALI parts and versions

1012.0
1032.0

Product properties

The application controller supports control gear with no device types, those with 1 device type and those with more than 1 device type. For certifications before October 2025, check with the manufacturer.

This product can be used to update the firmware of other products that implement part 105 Firmware Transfer.

Sensors, switches, push-buttons, etc.

Maximum current consumed from the bus power supply. If no value shown, 2mA is required.

“Other properties” do not imply certification to such standards.



Reference design of firmware or hardware available